Supero SuperServer 6026T-URF, Руководство пользователя

Страница: 49 / 98

Chapter 5: Advanced Serverboard Setup
5-17
LAN1/2 (Ethernet Ports)
Two Ethernet ports (designated LAN1
and LAN2) are located beside the VGA
port on the I/O backplane. These ports
accept RJ45 type cables.
UID Buttons
There are two Unit Identifi cation (UID)
buttons on the serverboard. The Front
Panel UID Switch connects to pin 13
of JF1. The Rear UID Switch (SW1) is
located next to LAN2. Pushing the UID
switch on the Front Control Panel will
illuminate both the Rear UID and the
Control Panel UID indicators. Push the
either switch again to turn off both in-
dicators. These UID indicators provide
easy identifi cation of a system that may
be in need of service.
IPMB I
2
C
A System Management Bus header
for the IPMI slot is located at IPMB.
Connect the appropriate cable here
to use the IPMB I
2
C connection on
your system.
IPMB I
2
C
Pin Defi nitions (IPMB)
Pin# Defi nition
1 Data
2 Ground
3 Clock
4 No Connection
Power SMB (I
2
C) Connector
The Power System Management Bus
(I
2
C) header (JPI
2
C) is used to moni-
tor the power supply, fan and system
temperatures. See the table on the
right for pin defi nitions.
PWR SMB
Pin Defi nitions (JPI
2
C)
Pin# Defi nition
1 Clock
2 Data
3 PWR Fail
4 Ground
5 +3.3V