Supero SUPERSERVER 5026T-3F, Руководство пользователя

Страница: 22 / 100

2-8
S
UPER
S
ERVER 5026T-3F/5026T-T Manual
2-5 Checking the Motherboard Setup
After you install the 5026T-3F/5026T-T in the rack, you will need to open the unit
to make sure the motherboard is properly installed and all the connections have
been made.
Accessing the Inside of the System
Release the retention screws that secure the unit to the rack. 1.
Grasp the two handles on either side and pull the unit straight out until it 2.
locks (you will hear a "click").
Depress the two buttons on the top of the chassis to release the top cover. 3.
There is a large rectangular recess in the middle front of the top cover to 4.
help you push the cover away from you until it stops. You can then lift the
top cover from the chassis to gain full access to the inside of the server. See
Figure 2-5.
Checking the Components and Setup
You should have one processor already installed into the motherboard. The 1.
processor needs a heatsink installed. See Chapter 5 for instructions on pro-
cessor and heatsink installation.
Your 5026T-3F/5026T-T server system may have come with system memory 2.
already installed. Make sure all DIMMs are fully seated in their slots. For
details on adding system memory, refer to Chapter 5.
If desired, you can install add-on cards to the system. See Chapter 5 for 3.
details on installing PCI add-on cards.
Make sure all power and data cables are properly connected and not blocking 4.
the chassis airfl ow. Also make sure that no cables are positioned in front of
the fans. See Chapter 5 for details on cable connections.