Supero SuperServer 5016I-MR, Руководство пользователя

Страница: 84 / 114

6-6
S
UPER
S
ERVER 5016I-MR/5016I-MRF User's Manual
6-5 Power Supply
The SuperServer 5016I-MR/5016I-MRF has a single 200 watt power supply. This
power supply has the capability of operating at 100 - 240 input volts. Power down
the system and then unplug the AC power cord to completely remove power from
the system before removing the power supply.
Power Supply Failure
If the power supply unit fails, the system will shut down and you will need to replace
the power supply unit. Replacement units can be ordered directly from Supermicro
(PWS-201-1H - see contact infomation in Chapter 1).
Replacing the Power Supply
1. Power down the system (if on) and unplug the power cord.
2. Grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click").
3. Depress the two buttons on the top of the chassis to release the top cover
and push it away from you. You can then lift the top cover from the chassis to
gain full access to the inside of the server.
4. To remove the failed power unit, remove the two screws on the back of the
power supply and a third from the front of the power supply, which secures
it to the bottom of the chassis. You can then lift the unit straight out of the
chassis.
5. Replace the failed unit with another unit of the same wattage. It is highly
recommended to replace it with the exact same power supply.
6. Carefully insert the new unit into position in the chassis and secure it with the
two screws at the rear of the unit and the third at the front.
7. Reconnect the power cord, replace the chassis top cover and push the unit
back into the rack.
8. Finish by depressing the power button on the front of the system.