Supero SUPERSERVER 5016I-M6F, Руководство пользователя

Страница: 43 / 102

Chapter 5: Advanced Motherboard Setup
5-9
5-6 Installing Memory
Note : Check the Supermicro web site for recommended memory modules.
CAUTION
Exercise extreme care when installing or removing DIMM modules to
prevent any possible damage.
DIMM Installation
Insert the desired number of DIMMs into the memory slots, starting with 1.
DIMM1A. Insert each DIMM module vertically into its slot. Pay attention to
the notch along the bottom of the module to prevent incorrect DIMM module
installation.
Gently press down on the DIMM module until it snaps into place in the slot. 2.
Repeat step 1 to install DIMM1B if needed.
Memory Support
The X8SI6-F supports up to 16GB of DDR3 ECC UDIMM or up to 32GB of ECC
DDR3 RDIMM (1333/1066/800 MHz in 6 DIMM slots.) Populating these DIMM
slots with a pair of memory modules of the same type and same size will result
in interleaved memory, which will improve memory performance. Please refer to
the table below:
Platform DIMM Type Intel® Xeon® Series Processors
X8SI6-F Non-ECC UDIMM Only Not Supported
ECC UDIMM Only Supported (see Table 1)
RDIMM Only (with ECC) Supported (see Table 2)
Mixed ECC with non-ECC Not Supported
Mixed UDIMM/RDIMM Not Supported
Table 1 - DDR3 ECC/Unbuffered (UDIMM) Memory Support
ECC UDIMM 1Gb (x8 DRAM) 2Gb (x8 DRAM)
Single Rank Up to 4GB
(4 x 1GB DIMM Modules) Up to 8GB
(4 x 2GB DIMM Modules)
Dual Rank Up to 8GB
(4 x 2GB DIMM Modules) Up to 16GB
(4 x 4GB DIMM Modules)
Quad Rank Not Supported Not Supported