Supero SUPERSERVER 2027TR-D70RF+, Руководство пользователя

Страница: 27 / 144

Chapter 2: Server Installation
2-9
Optional Quick Installation Method
The following quick installation method may be used to install the chassis onto a
rack.
Installing the Chassis into a Rack
1. Install the whole rail assembly onto the rack as described on page 2-7.
2. Release the inner rail without retracting the middle rail.
3. Install the inner rails on the chassis as previously described on page 2-6.
4. Install the chassis onto the middle rail as described in the previous section.
Warning : do not pick up the server with the front handles. They are designed
to pull the system from a rack only.
Stability hazard. The rack stabilizing mechanism must be in place, or the
rack must be bolted to the fl oor before you slide the unit out for servicing.
Failure to stabilize the rack can cause the rack to tip over.
2-6 Checking the Serverboard Setup
After you install the SUPERSERVER 2027TR-D70RF+ in the rack, you will need
to open the unit to make sure the serverboard is properly installed and all the
connections have been made.
Accessing the inside of the System
Before operating the SC217 chassis for the fi rst time, it is important to remove the
protective fi lm over the cover of the chassis, in order to allow for proper ventilation
and cooling.
Removing the Chassis Cover and Protective Film (Figure 2-7)
1. Confi rm that the power cord has been removed from the rear of both power
supplies.
2. Peel off the protective fi lm covering the top cover and the top of the chassis
3. Remove the two screws which secure the top cover onto the chassis as
shown above.
4. Lift the top cover up and off the chassis.
5. Check that all ventilation openings on the top cover and the top of the chassis
are clear and unobstructed.
6. Replace the chassis cover and reconnect the AC power cord.