Supero SUPERSERVER 1027R-WRF, Руководство пользователя

Страница: 68 / 108

6-2
SUPERSERVER 1027R-WRF USER'S MANUAL
Figure 6-1. Chassis: Front and Rear Views
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the JF1
connector on the serverboard to provide you with system status indications. These
wires have been bundled together as a ribbon cable to simplify the connection.
Connect the cable from JF1 on the serverboard to the appropriate header on the
Control Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1
on both connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System
Interface" for details on the LEDs and the control panel buttons. Details on JF1 can
be found in "Chapter 5: Advanced Serverboard Setup."
6-3 System Fans
Five 4-cm counter-rotating fans provide the cooling for the system. Each fan unit is
actually made up of two fans joined back-to-back, which rotate in opposite directions.
This counter-rotating action generates exceptional airfl ow and works to dampen
vibration levels. The SC113 chassis provides two additional open fan housings,
where an additional system fan may be added for optimal cooling.
It is very important that the chassis top cover is properly installed and making a
good seal in order for the cooling air to circulate properly through the chassis and
cool the components. See Figure 6-2 System Fan Failure.
Adding a System Fan
1. Turn off the power to the system and unplug the power cord.
2. Remove the chassis cover then remove the dummy fan from the fan tray.
PCI Expansion Slots (w/ Riser Cards)
USB Ports COM1 Port
VGA Port Ethernet Ports
IPMI Port
Power Supply
DVD-ROM Drive (Optional
Hot-Swap Drive Bays (8)
Control Panel