Supero SuperServer 1026GT-TF, Руководство пользователя

Страница: 54 / 104

5-20
S
UPER
S
ERVER 1026GT-TF Series User's Manual
LAN1/2 Enable/Disable
Change the setting of jumper JPL1 to en-
able or disable the LAN1/LAN2 Ethernet
ports on the serverboard. See the table on
the right for jumper settings. The default
setting is enabled.
LAN1/2 Enable/Disable
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog Enable/Disable
JWD controls the Watch Dog function.
Watch Dog is a system monitor that can
reboot the system when a software appli-
cation hangs. Jumping pins 1-2 will cause
WD to reset the system if an application
hangs. Jumping pins 2-3 will generate a
non-maskable interrupt signal for the ap-
plication that hangs. See the table on the
right for jumper settings. Watch Dog must
also be enabled in BIOS.
Note: When enabled, the user needs to
write their own application software in order
to disable the Watch Dog Timer.
Watch Dog
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
J_UID-OW (Overwriting)
Jumper Settings
Jumper Defi nition
Open Red Fail LED overwrites the Blue
UID LED
Red LED: On, Blue LED: Off,
Red LED: Off, Blue LED: On or Off
Closed Red LED does not overwrite and has
no effect on the Blue UID LED
Red LED: On, Blue LED: On,Off
Red LED: Off, Blue LED: On, Off
J_UID_OW (Overwriting)
When J_UID_OW is set to open (default),
the red LED (Overheat/Fan Fail/PWR Fail/
UID LED) located on pin 8 of the Front
Control Panel (JF1) will take precedence
over the Blue UID_LED located on pin 7
of JF1. (That is, when the red LED is on
the blue LED will be turned off. When the
red LED is off, the blue UID_LED can be
on or off.) In other words, the red LED
signal overwrites the blue UID_LED signal
if J_UID-OW is set to off. When the jumper
J_UID_OW is closed, the red LED and
the Blue_UID_LED work independently of
each other and the red LED will have no
effect on the blue LED. See the table for
jumper settings.