Supero SUPER P3TDE6, Руководство пользователя

Страница: 28 / 90

2-4
S
UPER P3TDE6/P3TDER User’s Manual
2-3 Installing DIMMs
Note: Check the Supermicro web site for recommended memory modules:
http://www.supermicro.com/TECHSUPPORT/FAQs/Memory_vendors.htm
CAUTION
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage. Also note that the
memory is interleaved to improve performance (see step 1).
DIMM Installation (See Figure 2-2)
1. Insert either two or four DIMMs as required for the desired system
memory. Two-way interleaved memory requires that memory modules
be installed in pairs (first in the two slots of Bank0 and then in both
slots of Bank1, if needed).
2. Insert each DIMM module vertically into its slot. Pay attention to the two
notches along the bottom of the module to prevent inserting the DIMM
module incorrectly.
3. Gently press down on the DIMM module until it snaps into place in the
slot. Repeat for all modules (see step 1 above).
Support
The P3TDE6/P3TDER only supports ECC registered SDRAM memory. PC133
and PC100 memory are both supported at their respective speeds. How-
ever, the memory bus is synchronized to the front side bus speed, so using
PC100 with a 133 MHz FSB or using PC133 with a 100 MHz FSB, will result
in 100 MHz memory speed operation in either case.