Supero SUPER 370SSA, Руководство пользователя

Страница: 32 / 92

2-4
S
UPER 370SSA/370SSM User's Manual
Installation
Figure 2-2. DIMM Installation
Note: Notches
should align
with the
receptive points
on the slot
D I M M S l o t
Side View of DIMM Installation into Slot
DIMM
P C 1 0 0
Notches
P C 1 0 0
Notches
2-4 Installing DIMMs
CAUTION
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
DIMM Installation (See Figure 2-2)
1. Insert DIMMs in Bank 0 through Bank 2 as required for the desired
system memory.
2. Insert each DIMM module vertically into its slot. Pay attention to the
two notches along the bottom of the module to prevent inserting the
DIMM incorrectly.
3. Gently press down on the DIMM module until it snaps into place.
4. If installing only a single DIMM, you may use any Bank. The 370SSA/
370SSM will support a total of 512 MB of unbuffered SDRAM in its
three DIMM slots. ECC type memory is not supported. PC133 and
PC100 memory are both fully supported at their respective speeds.
However, if three DIMM modules are installed, the memory will run at
100 MHz, even if PC133 memory is used (this is a chipset limitation).
To Install:
Insert module
vertically and
press down
until it snaps
into place.
Pay attention
to the two
notches.