Supero FatTwin F627R3-R72B+, Руководство пользователя

Страница: 64 / 152

5-10
FatTwin F627R3-RTB+/R72B+ User's Manual
5-5 Installing Memory
Caution: exercise extreme care when installing or removing DIMM modules to prevent
any possible damage.
Installing Memory
1. Insert the desired number of DIMMs into the memory slots, starting with P1-
DIMM #1A. (For best performance, please use the memory modules of the
same type and speed in the same bank.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Reverse the steps above to remove the DIMM modules from the motherboard.
Note: 1 GB, 2 GB, 4 GB, 8 GB, 16 GB or 32 GB size memory modules are
supported. It is highly recommended that you remove the power cord from the
system before installing or changing memory modules. Please refer to our web site
for memory that has been tested on the X9DRFR serverboard.
To I n s t a l l : I n s e r t
module vertically and
press down until it
s n a p s i n t o p l a c e .
Pay attention to the
alignment notch at
the bottom.
To R e m o v e : U s e
your thumbs to gently
push the release tabs
near both ends of the
module. This should
release it from the
slot.
Top View of DDR3 Slot
Release Tab Release Tab
Note: Notch should align with
the receptive key point on
the slot.
Notch Notch
Front View
Figure 5-3. Installing DIMM into Slot