Supero 4042G-72RF4, Руководство пользователя

Страница: 55 / 122

Chapter 5: Advanced Serverboard Setup
5-7
5-5 Installing Memory
Caution: Exercise extreme caution when installing or removing memory modules to
prevent any possible damage.
Installing Memory
1. Insert each memory module vertically into its slot, paying attention to the
notch along the bottom of the module to prevent inserting the module
incorrectly (see Figure 2-1).
2. Install to slots CPU1/DIMM1A, CPU1/DIMM2A, CPU1/DIMM3A and CPU1/
DIMM4A, etc. Always install in groups of four and in the numerical order of
the DIMM slots. See support information below.
3. Gently press down on the memory module until it snaps into place.
4. With four DIMMs installed, repeat step 2 to populate the CPU2 DIMM
slots. Always install four DIMMs to both CPU DIMM slots for more efficient
operation.
Note:
Memory modules of 1 GB, 2 GB, 4 GB, 8 GB, 16 GB or 32 GB size are
supported. It is highly recommended that you remove the power cord from the
system before installing or changing memory modules. Please refer to our web site
for memory that has been tested on the H8QG7-LN4F serverboard.
Memory Support
The H8QG7-LN4F serverboard supports thirty-two (thirty-two (32)) single/dual/tri/
quad-channel, DDR3-1600/1333/1066 Mhz SDRAM memory modules.
Populating four adjacent slots at a time with memory modules of the same size and
type will result in interleaved (128-bit) memory, which is faster than non-interleaved
(64-bit) memory.
Maximum Memory
The H8QG7-LN4F serverboard supports a maximum memory of up to 256 GB of
ECC/Non-ECC UDIMM or up to 1 TB of ECC RDIMM SDRAM.