Supero 1042G-TF, Руководство пользователя, Страница: 102 / 118

7-8
A+ SERVER 1042G-TF User's Manual

PCI/PNP Configuration
Clear NVRAM
Select Yes to clear NVRAM during boot-up. The options are Yes and No .
Plug & Play O/S
Select Yes to allow the OS to configure Plug & Play devices. (This is not required
for system boot if your system has an OS that supports Plug & Play.) Select No to
allow AMIBIOS to configure all devices in the system.
PCI Latency Timer
This option sets the latency of all PCI devices on the PCI bus. Select a value to
set the PCI latency in PCI clock cycles. Options are 32,
64 , 96, 128, 160, 192,
224 and 248.
PCI IDE Busmaster
Use this setting to
Enable
or Disable BIOS enabled uses of PCI Busmastering for
reading or writing to IDE drives.
Slot 1 ~ Slot 4 PCI-E OPROM
These four settings (Slot 1 through Slot 4) allow you to enable or disable the
numbered slot's Op ROM, except for the VGA card.
UIO PCI-E OPROM
This setting allows you to enable or diable the UIO slot Op ROM, except for the
VGA card.
Onboard NIC Option ROM Select
This setting allows you to disable or select the onboard NIC option ROM. Options
include
Disabled , PXE and iSCSI.

SuperI/O Configuration
Serial 1 Address
This option specifies the base I/O port address and Interrupt Request address
of serial port 1. Select "Disabled" to prevent the serial port from accessing any
system resources. When this option is set to Disabled , the serial port physically
becomes unavailable. Select "3F8/IRQ4" to allow the serial port to use 3F8 as its
I/O port address and IRQ 4 for the interrupt address. Options include Disabled,
3F8/IRQ4 , 3E8/IRQ4 and 2E8/IRQ3
Serial 2 Address