2-26
X10DRT-P/PT/PIBQ/PIBF Motherboard User’s Manual
JBT1
P1-DIMMB2
S-SA
TA3
IB CODE
BAR CODE
BIOS
LICENSE
COM1
JIPMB1
FAN3
FAN4
JSD1 JTPM1
JF1
UID_LED1
BMC_HB_LED1
JPG1 JPB1
JVRM2
JVRM1
JWD1
JPL1
/CPU2 PCI-E 3.0 X16)
(CPU2 SLOT1 PCI-E 3.0 X16)
PCI-E 3.0 X8)
(CPU2 SLOT2
UID SW
BATTERY
BIOS
BMC
VGA
QSFP
LAN1/LAN2
IB
10G/1G
(3.0)
USB0/1
IPMI_LAN
SA
TA
DOM+POWER
TPM/POR
T80
CPU2_VRM_HS1
CPLD
P2-DIMMG1
P2-DIMMH2
P2-DIMMH1
P2-DIMMG2
P2-DIMMF2
P2-DIMME1
P2-DIMME2
P2-DIMMF1
P1-DIMMD2
P1-DIMMD1
P1-DIMMC2
P1-DIMMC1
P1-DIMMB1 P1-DIMMA2 P1-DIMMA1
/CPU1PCI-E 3.0 X8)
(I-SA
TA0~5
CPU2
CPU1
LAN CTRL
PCH
IB_LINK_LED1
IB_ACT_LED1
(S-SA
TA0~2
SXB1
SXB2
Slot1
Slot2
SXB1
SXB2
X10DRT-P Series
Rev. 1.10
CMOS Clear
JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact pads
to prevent accidental clearing of CMOS. To clear CMOS, use a metal object such
as a small screwdriver to touch both pads at the same time to short the connection.
Always remove the AC power cord from the system before clearing CMOS.
Note:
Be sure to remove the onboard CMOS Battery before you short
JBT1 to clear CMOS.
A. Clear CMOS
B. Watch Dog
Watch Dog Enable/Disable
Watch Dog (JWD1) is a system monitor that
can reboot the system when a software ap-
plication hangs. Close pins 1-2 to reset the
system if an application hangs. Close pins
2-3 to generate non-maskable interrupt sig-
nals for the application that hangs. See the
table on the right for jumper settings. Watch
Dog must also be enabled in the BIOS.
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2
Reset (default)
Pins 2-3
NMI
Open
Disabled
A
B
