Chapter 2: Installation
2-11
Release Tabs
Notches
2-4 Installing and Removing the Memory Modules
Note
: Check Supermicro's website for recommended memory modules.
CAUTION
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with
P1-DIMMA1. (For best performance, please use the memory modules of the
same type and speed in the same bank.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
Removing Memory Modules
Press the release tabs on both ends of the memory module to unlock it. Once it is
loosened, remove the DIMM module from the memory slot.
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Press both notches straight
down into the memory slot at
the same time.
JBT1
P1-DIMMB2
S-SA
TA3
IB CODE
BAR CODE
BIOS
LICENSE
COM1
JIPMB1
FAN3
FAN4
JSD1 JTPM1
JF1
UID_LED1
BMC_HB_LED1
JPG1 JPB1
JVRM2
JVRM1
JWD1
JPL1
/CPU2 PCI-E 3.0 X16)
(CPU2 SLOT1 PCI-E 3.0 X16)
PCI-E 3.0 X8)
(CPU2 SLOT2
UID SW
BATTERY
BIOS
BMC
VGA
QSFP
LAN1/LAN2
IB
10G/1G
(3.0)
USB0/1
IPMI_LAN
SA
TA
DOM+POWER
TPM/POR
T80
CPU2_VRM_HS1
CPLD
P2-DIMMG1
P2-DIMMH2
P2-DIMMH1
P2-DIMMG2
P2-DIMMF2
P2-DIMME1
P2-DIMME2
P2-DIMMF1
P1-DIMMD2
P1-DIMMD1
P1-DIMMC2
P1-DIMMC1
P1-DIMMB1 P1-DIMMA2 P1-DIMMA1
/CPU1PCI-E 3.0 X8)
(I-SA
TA0~5
CPU2
CPU1
LAN CTRL
PCH
IB_LINK_LED1
IB_ACT_LED1
(S-SA
TA0~2
SXB1
SXB2
Slot1
Slot2
SXB1
SXB2
X10DRT-P Series
Rev. 1.10
