SuperServer E403-9P-FN2T User's Manual
40
Note
: When you add or change an expansion card,
and
if you load the BIOS default, clear
CMOS, or update your BIOS, you must configure:
UEFI BIOS > Advanced tab > Chipset Configuration > North Bridge > IIO Configuration
> CPU Configuration
. The setting for
IOU2
is x8x8 or x16. The setting for
IOU1
is Auto.
Installing or Replacing the Expansion Card Module
1. Power down the system as described in Section 2.1 and remove the chassis cover.
2. Remove the screw, as shown in the diagram on the following page.
3. Pull the locking lever up to release the expansion card module.
4. Pull the expansion card module upward with the aid of the plastic handle.
5.
Be sure the JSEL1 jumper is set as you want it.
6. In the removed expansion card module, install expansion cards. For full height cards,
install first in the top-most slot, then the middle, and then the bottom slot. Note that you
must also modify the main air shroud to fit full height cards. (See previous section.)
7. Replace the expansion card module.
8. Reinstall the chassis top cover, reconnect the AC power cord and power up the system.
Caution:
If installing three NVIDIA T4 GPUs in the expansion cards module, the processor
must consume less than or equal to 165W TDP.
This screenshot shows the
x8 x8 configuration for IOU2.
