Supermicro SUPERSERVER 8045C-3R, Руководство пользователя

Страница: 62 / 118

6-6
S
UPER
S
ERVER 8045C-3R User's Manual
Installing/Removing Hot-swap SAS/SATA Drives
The SAS/SATA drive carriers are all easily accessible at the front of the chassis.
These drives are hot-swappable, meaning they can be removed and installed with-
out powering down the system.
Open the front bezel then push the release button located beside the drive
LEDs.
Swing the handle fully out and then use it to pull the drive straight out.
Note: Your operating system must have RAID support to enable the hot-swap
capability of the SAS/SATA drives.
Mounting a SAS/SATA Drive in a Drive Carrier
The SAS/SATA drive carriers help to promote proper airfl ow for the system. For this
reason, even carriers without SAS/SATA drives must remain in the server.
Insert the drive into the carrier with the printed circuit board side facing down
so that the mounting holes align with those in the carrier.
Secure the drive to the carrier with four screws (see Figure 6-5).
SAS/SATA Backplane
The SAS/SATA drives plug into a SAS/SATA backplane on the CSE-M35P mobile
rack, which houses the SAS drive bays. The SAS data cables must be connected
from the serverboard to the appropriate connectors on the backplane. There are
also two power connectors on the backplane - both should be connected.
1.
2.
1.
2.
6-4 Drive Bay Installation
SAS/SATA Drives
A total of fi ve SAS or SATA drives may be housed in the SC748TQ-R1200 chassis.
The drive IDs are preconfi gured as 0 through 4 in order from right to left (or from
bottom to top if rackmounted).
Regardless of how many SAS/SATA drives are installed, all
drive carriers must remain in the drive bays to promote proper
airfl ow.
!