Supermicro SUPERSERVER 6036ST-6LR, Руководство пользователя, Страница: 50 / 110

5-2
S
UPER
S
ERVER 6036ST-6LR User's Manual
Unpacking
The serverboard is shipped in antistatic packaging to avoid electrical static dis-
charge. When unpacking the board, make sure the person handling it is static
protected.
5-2 Cable and Device Connectiions
All data and power connections between the serverboard to the system (including
the power supplies and the hard drives) are provided through the midplane. Most of
these connections are made automatically when the system is assembled. "Right"
and "left" refer to the side of the chassis as viewed from the front of the system.
Also refer to Chapter 6 Section 5 for an image of the midplane with the connec-
tions listed below.
Power Connections
Power is routed from the power supplies to the power distribution board which in
turn connects to the midplane. When the serverboards are seated in their bays they
plug into the midplane to receive power.
Fan Cabling
On each side of the midplane are three 4-pin fan headers. These are cabled to the
fans that reside in the fan assemblies located above each node/serverboard. The
fans on the serverboards themselves (one each) connect to the "Fan1" header on
the serverboard.
Control Panels
A ribbon cable connects each control panel to the midplane. The right and left side
control panels connect to JP1 and JP2 on the midplane, respectively.
SSB Connections
Along one end of each serverboard are several square SSB (Simulation Service
Bus) headers. These headers provide logic, data and power to the serverboards.
The connections to these headers are made automatically when the serverboard
is fully seated in its bay within the chassis.