Supermicro SUPERSERVER 6021F, Руководство пользователя

Страница: 25 / 116

Chapter 2: Server Installation
2-9
6. Check all cable connections and airflow:
Make sure all power and data cables are properly connected and not
blocking the airflow. See Section 5-3 for details on cable connections.
Also, check the air seals for damage. The air seals are located under
the blower fan and beneath the frame cross section that separates the
drive bay area from the motherboard area of the chassis.
2-6 Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the SCSI
drives and SCA backplane have been properly installed and all connections
have been made.
1. Accessing the drive bays:
All drives can be accessed from the front of the server. For servicing
the CD-ROM and floppy drives, you will need to remove the top chassis
cover. The SCSI disk drives can be installed and removed from the front
of the chassis without removing the top chassis cover. The 5.25" drive
bay cover can be removed by pressing the tab on the corner of the drive
bay and then push the bay outward from inside.
2. Installing components into the 5.25" drive bay:
Remove the drive bay cover by pressing the tab as decribed in the
previous section. Remove the drive bay rails as shown in Figure 2-6.
Install the rails onto the new component and then slide the new compo-
nent into the drive bay until you hear a clicking sound from the tab.
3. Installing CD-ROM and floppy disk drives:
Refer to Section 6-4 if you need to reinstall a CD-ROM and/or floppy disk
drive to the system.
4. Check the SCSI disk drives:
Depending upon your system's configuration, your system may have one
drive already installed. If you need to install SCSI drive, please refer to
Section 6-4.