Supermicro SUPERSERVER 6013P-8 Plus, Руководство пользователя

Страница: 39 / 108

Chapter 5: Advanced Serverboard Setup
5-3
Figure 5-1. 604-pin PGA Socket: Empty and with Processor Installed
Warning!
Make sure you lift the lever completely when
installing the CPU. If the lever is only partly raised, damage
to the socket or CPU may result.
!
4. Place the heatsink directly on the CPU so that the four mounting holes are aligned
with those on the chassis. Make sure the heatsink sits completely flat on the CPU
- if not completely flat, the space between the two will degrade the heat dissipation
function of the heatsink, which may cause the processor to overheat.
5. Screw in two diagonal screws (#1 and #2 or #3 and #4) until just snug (do not fully
tighten), then do the same with the remaining two diagonal screws. Finish by fully
tightening all four screws (see Figure 5-2).
6. If installing two processors, repeat these steps to install the second processor in
the CPU #2 slot.