Supermicro SUPERSERVER 1028TR-T, Руководство пользователя

Страница: 76 / 144

5-24
SUPERSERVER 1028TR-T/TF User's Manual
Infi niBand Enable (JIB1)
Jumper Settings
Jumper Setting Defi nition
1-2 Enabled (Default)
2-3 Disabled
VGA Enable (JPG1)
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
I2C to PCI-E (JI2C1/JI2C2)
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled (Default)
VGA Enable
Jumper JPG1 allows the user to enable
the onboard VGA controller. The default
setting is 1-2 to enable the connection.
See the table on the right for jumper
settings.
GLAN Enable/Disable
JPL1 enables or disables the GLAN 1/2
ports on the motherboard. See the table
on the right for jumper settings. The
default setting is Enabled.
GLAN Enable
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Enabled (default)
Pins 2-3 Disabled
Watch Dog Enable/Disable
The Watch Dog (JWD1) is a system
monitor that will reboot the system when
a software application hangs. Close
pins 1-2 to reset the system if an appli-
cation hangs. Close pins 2-3 to generate
a non-maskable interrupt signal for the
application that hangs. See the table on
the right for jumper settings. The Watch
Dog must also be enabled in the BIOS.
Watch Dog (JWD1)
Jumper Settings
Jumper Setting Defi nition
Pins 1-2 Reset (default)
Pins 2-3 NMI
Open Disabled
I 2 C Bus to PCI-Express Slots
Use Jumpers JI 2 C1 and JI 2 C2 to connect
the System Management Bus (I 2 C) to
PCI-Express slots. These two jumpers
should be set at the same time. See the
table on the right for jumper settings.
Infi niBand Enable (Optional for the
X10DRT-LIBF/LIBQ)
Jumper JIB1 allows the user to enable
the InfiniBand controller for High-
Performance Computing (HPC) support
on the X10DRT-LIBF/LIBQ. The default
setting is 1-2 (Enabled). See the table on
the right for jumper settings.