Supermicro Supero SUPERSERVER 5086B-TRF, Руководство пользователя

Страница: 41 / 106

Chapter 5: Advanced Setup
5-7
Installing a CPU Board to the Baseboard
After populating the CPU board with the desired components and reinstalling the
air shroud, you must install the CPU module to the baseboard.
Locate the CPU board slots on the X8OBN baseboard. 1.
Using both hands, grab the two handles on the CPU module keeping the 2.
CPU bracket facing toward the PCI-E slot area.
With the back plate (marked "Front") toward the left side of the chassis, align 3.
the edge of the CPU board bracket with the guide rails, which are located on
the middle fan bracket and the rear of the chassis.
Insert the CPU module into the guide rails until the bottom of the CPU board 4.
contacts the top of the CPU board slot. The gold fi ngers at the bottom of the
board should contact the slots at the same time that the handles touch the
frame.
Make sure the notch on each of the latches has entered the frame, then 5.
press both handles inward to close them. Gently push the CPU board into the
slot until it is fully seated.
Press the red latches on the handles inward to lock the handles on the CPU 6.
board bracket, which will secure the CPU module in place.
Rev. 1.01
X8OBN-F Baseboard
X8OBN Baseboard
CPU Module Locked in Place
CPU Board Slot 1
CPU Board Slot 2
CPU Board Slot 3
CPU Board Slot 4
If the CPU modules are not properly installed, the CPUs may sustain dam-
age after powering on the system.
!