Supermicro Supero SUPERSERVER 5086B-TRF, Руководство пользователя

Страница: 25 / 106

Chapter 2: Server Installation
2-11
2-6 Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the SATA drives and
backplane have been properly installed and all connections have been made.
Checking the Drives
All drives can be accessed from the front of the server. For servicing the pe- 1.
ripheral drives, you will need to remove the top/left chassis cover. The SATA
disk drives can be installed and removed from the front of the chassis without
removing any chassis covers.
To install components into the 5.25" drive bays, you must fi rst remove the 2.
top/left chassis cover as described in the previous section. Refer to Chapter 6
for details.
Depending upon your system's con fi guration, your system may have one or 3.
more drives already installed. If you need to install SATA drives, please refer
to Chapter 6.
Checking the Air fl ow
Air fl ow is provided by four hot-swap 9-cm chassis fans working in conjunction 1.
with four air shrouds. Two 9-cm exhaust fans are also mounted at the rear of
the chassis. The system component layout was carefully designed to promote
suf
fi cient air fl ow through the chassis.
Note that all power and data cables have been routed in such a way that they 2.
do not block the air fl ow generated by the fans. Keep this in mind when you
reroute them after working on the system.
Supplying Power to the System
The last thing you must do is to provide input power to the system.
Plug the power cords from the power supplies unit into a high-quality power 1.
strip that offers protection from electrical noise and power surges.
It is recommended that you use an uninterruptible power supply (UPS). 2.
Depress the power on button on the front of the chassis. 3.