Supermicro SSE-X3348T, Руководство по установке

Страница: 44 / 74

SSE-X3348T/ SSE-X3348TR Switch Installation Manual
4-8
Task 5: Make Initial Configuration Changes
At this point you may need to make a few basic switch configuration changes before
connecting to the network. It is suggested to connect to the switch console port to
perform this task.
The serial port’s configuration requirements are as follows: 9600 bps, 8 characters, no
parity, one stop bit, 8 data bits, and no flow control.
You can log in to the command-line interface (CLI) using default settings: User “ADMIN”,
password “ADMIN”.
Go to Section 7-2: "How to Connect to the Console Port" on page 7-2 .
For information on initial switch configuration refer to the 1/10 and 10-Gigabit Layer 2/3
Ethernet Switches User’s Manual .
Figure 4-4. Console Port
Console Port