Supermicro SC946ED-R2KJBOD, Руководство пользователя

Страница: 46 / 76

SC946ED Chassis Manual
4-8
7. Disconnect the 20-pinPDB control cable from the mid-plane.
8. Grasp the front edge of the backplane tray and pull it forward, but not all the
way out of the chassis if you are checking cable connections. Pull the back-
plane tray all the way out if you are removing and replacing the backplane
tray.
9. Check the cabling as directed by Supermicro Technical Support or return the
entire backplane tray to Supermicro.
Closing the Backplane Tray
1. Reconnect the front control cable, PDB control cable and 8-pin power con-
nector at the back of the backplane tray. and slide the backplane tray fully
into the chassis.
2. Tighten the thumbscriew at the front of the backplane tray
3. Secure the front panel with the screws previously set aside.
4. Install the PDB back into the chassis and reconnect all of the cables.
5. Return the power cage to the chassis and secure it with the screws previ-
ously set aside, then push the power supplies into the power bays until they
click into the locked position.
6. Plug the power cords into the rear of the power supplies, close and latch the
chassis cover and then power up the system.
Figure 4-8. Closing the Backplane Tray
4
3
1
1
1
1
2
Secure the
Front Panel
Thumbscrew
Front Control Panel
Cable Connector
Backplane Tray (A)
Power Cable
Connector