Supermicro SC946ED-R2KJBOD, Руководство пользователя, Страница: 42 / 76

SC946ED Chassis Manual
4-4
Figure 4-2. Removing the Front Panel
The SC946ED features a front panel which must be removed before pulling out
the backplane tray.
Front Panel Removal and Installation
Removing the Front Panel
1. Power down the system as described in Section 4-2. Unplug the power cords
from the rear of the power supplies.
2. Remove the seven screws securing the face of the front panel and set them
aside for later use.
3. Remove the three screws securing the underside of the front panel and set
them aside for later use.
Grasp the front panel and carefully pull it off the front of the chassis.
Installing the Front Panel
1. Place the front panel on the front of the chassis.
2. Align the mounting holes in the front panel with those of the chassis.
3. Install the seven front screws that were previously set aside.
4. Install the three underside screws that were previously set aside.
5. Plug the power cords into the rear of the power supplies and power up the
system.
4-4 Front Panel Removal and Installation
Remove Three
Lower Front
Screws
Remove Four
Front Screws