A+ Server AS -2123BT-Hxxx User's Manual
72
transmission speed may be required for long and busy lines. The options are 9600, 19200,
57600, and
115200
(bits per second).
Flow Control
Use this item to set the flow control for Console Redirection to prevent data loss caused
by buffer overflow. Send a "Stop" signal to stop sending data when the receiving buffer
is full. Send a "Start" signal to start sending data when the receiving buffer is empty. The
options are
None,
Hardware RTS/CTS, and Software Xon/Xoff.
Data Bits
Parity
Stop Bits
PCI-E/PCI/PnP Configuration
This menu provides PCI-E/PCI/PnP configuration settings and information.
PCI Bus Driver Version
Above 4G Decoding
This setting
Enables
or Disables 64-bit capable devices ability to be decoded in above 4G
address space (only if the system supports 64-bit PCI decoding).
SR-IOV Support
If the system has SR-IOV capable PCI-E devices, this setting will Enable or
Disable
the
Single Root IO Virtualization Support for the system.
PCI-E Spread Spectrum
Use this setting to Enable or
Disable
PCI-E Spread Spectrum for your system.
Target Link Speed
If supported by hardware and set to Force to x.S GT/S (x being a value of 2.5, 5.0 or 8.0) for
Downstream Ports, this sets an upper limit on Link Operational Speed by restricting the values
advertised by the UPstream component in its training sequences. When
Auto
is selected,
the HW initialized data will be used.
VGA Priority
Use this setting to select between onboard or offboard VGA support The options are
Onboard
and Offboard
NVMe Firmware Source
Use this setting to select between the AMI Native firmware support or the device vendor-
defined firmware support. The options are AMI Native Support and
Vendor Defined Firmware.
