Supermicro 8048B-TR4FT, Руководство пользователя

Страница: 59 / 135

Chapter 5: Advanced Serverboard Setup
5-9
Removing the Heatsink
Caution: We do not recommend that the CPU or the heatsink be removed. However,
if you do need to uninstall the heatsink, please follow the instructions below to uninstall
the heatsink to prevent damage done to the CPU or the CPU socket.
1. Unscrew the heatsink screws from the serverboard in the sequence as shown
in the illustration below.
2. Gently wriggle the heatsink to loosen it from the CPU. (Do not use excessive
force when wriggling the heatsink!)
3. Once the CPU is loosened, remove the CPU from the CPU socket.
4. Remove the used thermal grease and clean the surface of the CPU and the
heatsink, Reapply the proper amount of thermal grease on the surface before
reinstalling the CPU and the heatsink.5-5 Installing Memory
Caution: exercise extreme care when installing or removing DIMMs to prevent any
possible damage. DIMMs should be installed with the memory card removed from the
baseboard. See the tables on page 5-12 for details on populating memory.
Installing Memory
Insert the desired number of DIMMs into the slots on a memory card in the order
shown in Figure 5-4 and Figure 5-5. For best performance, use the memory modules
of the same type and speed.
5. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
6. Align the key of the DIMM module with the receptive point on the memory
slot.
7. Press both ends of the module straight down into the slot until the module
snaps into place.
8. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
9. Reverse the steps above to remove DIMM modules.
Memory Support
With all eight cards fully populated, the system will support up to a total of 12 TB
of DDR4-1866/1600/1333/1066 MHz speed ECC RDIMM/3DS LRDIMM memory.
Check the Supermicro website ( www.supermicro.com ) for the latest memory support
information.