Supermicro 5025M-4, Руководство пользователя

Страница: 39 / 120

Chapter 5: Advanced Motherboard Setup
5-3
5-3 Connecting Cables
Now that the motherboard is installed, the next step is to connect the cables to
the board. These include the data (ribbon) cables for the peripherals and control
panel and the power cables.
Connecting Data Cables
The ribbon cables used to transfer data from the peripheral devices have been care-
fully routed to prevent them from blocking the fl ow of cooling air that moves through
the system from front to back. If you need to disconnect any of these cables, you
should take care to keep them routed as they were originally after reconnecting
them (make sure the red wires connect to the pin 1 locations). The following data
cables (with their locations noted) should be connected. (See the layout on page
5-9 for connector locations.)
5025M-4: SCSI drive cable (JA1)
5025M-i: SATA drive cables (SATA#0-3)
Control Panel cable (JF1)
Floppy cable (J27)
CD-ROM drive cable (J3)
Connecting Power Cables
The PDSM4/PDSME has a 24-pin primary power supply connector (JPW1) for con-
nection to the ATX power supply. In addition, there is an 8-pin secondary power
connector (JPW2) that also must be connected to your power supply. See Section
5-9 for power connector pin defi nitions.
Connecting the Control Panel
JF1 contains header pins for various front control panel connectors. See Figure 5-1
for the pin locations of the various front control panel buttons and LED indicators.
All JF1 wires have been bundled into a single ribbon cable to simplify this connec-
tion. Make sure the red wire plugs into pin 1 as marked on the board. The other
end connects to the Control Panel PCB board, located just behind the system status
LEDs on the chassis. See Chapter 5 for details and pin descriptions.