16
ATTACHING THE TOP FILTER BAG
Disconnect the machine from the power
source!
1) Place a large 5/16” flat washer on a 5/16” hex head
screw
2) Position the bracket (A) on the dust collector (fig. 9).
3) Insert 5/16” hex head screw through the hold in the
bracket, then thread it into the hole in the dust collector.
Tighten securely with a 12mm wrench.
4) Thread the other two screws into the appropriate
holes and tighten securely.
5) Insert the rod into the pocket on the filter bag (A) (Fig.
10).
6) Insert the rod into the hole in the bracket (B) (Fig. 10).
7) Compress snap ring of the bottom of the filter bag and
fit inside the lip (A), snug, as shown in fig. 11
ATTACHING THE HOSE TO THE INTAKE
PORT
Disconnect the machine from the power
source!
1) Place the open end (A) of the intake cap rings on the
ends of each dust intake port before attaching the hose.
2) Loosely attach the hose clamp (B) Fig. 12 around one
end of the flexible hose. Attach the hose to the dust
intake port with a Philips screwdriver (C). Attach the
remaining clamp to the other end of the flexible hose
and to the woodworking machine.
NOTE: Do not operate the dust collector with any dust
intake port uncovered. Place the flat intake cap on the
dust intake port that is open.
A
Fig. 9
Fig. 10
A
B
A
B
Fig. 12
C
A
Fig. 11
