Programming the Operator
11. Preparation
11.1 Make sure the carriage is locked into automatic mode. Lift and lower the door by hand to
confirm the carriage is locked onto the belt connector.
11.2 Connect the AGDO to a properly earthed power supply using the power chord provided.
Make sure that no excess chord hangs below the AGDO when it is plugged in
.
11.3 Switch the power on at the power supply. The courtesy light will glow for several seconds.
At the same time the LED display will flash various sequences until it stops at two vertical
lines “
11”
. When the screen shows “
11
“ the opener is in standby. (fig.10)
11.4
Note: When in standby, a short press of the “Set” button will clear all error and alarms,
and then return to standby.
11.5
When in settings a short press of the “Code” button will return to standby.
11.6
A long press of the “Set” button will put the AGDO in “Program” mode.
11.7
A long press of the “Down” button will restore factory settings.
12. Coding and Deleting Transmitters
12.1 This AGDO will store 5 to 50 transmitter codes. When the AGDO is full, the LED display
will flash “F”.
12.2
To code a new transmitter, momentarily press the “Code” button. A red dot “
.
” will be
displayed on the LED screen. Momentarily press the button you wish to code on the
transmitter. Momentarily press the same button on the transmitter a second time. The
dot will flash on the LED display then change to standby. This indicates the transmitter
code is now stored.
12.3 To code additional transmitters repeat step 12.2.
12.4 To delete codes from the AGDO press and hold the “Code” button for approx. 6 seconds.
“C” will display on the LED screen indicating all transmitter codes have been deleted.
SETTINGS & ADJUSTMENTS
Fig. 10
Fig. 9
