6
3. Adjusting Safety Force (Sensitivity)
Force setting range is between 1
– 9
a. Press and hold
SET
until the LED displays number
3
. Factory setting is 3.
b. Press
UP
to increase the force by one degree and
DOWN
to decrease the force by one
degree. Maximum degree is
9
and the minimum degree is
1
.
c. Press
SET
to store your setting.
4. Photo beam setting (OPTIONAL)
Make sure the photo beams have been installed correctly before setting the Photo beam
function.
a. Press and hold
DOWN
until the LED displays
II
.
b. Press the
UP button
once. The LED displays
H
. Photo beam function is on. Press the
DOWN
button the LED displays
II
to cancel Photo Beam function.
c. Press
SET
to store your setting.
5. Setting Auto Close Function
a. Press and hold
UP
until the LED displays
0.
b. Press
UP
once, the auto close time will increase by
1
minute, the maximum time is 9
minutes. Press
DOWN
once, the auto close time will decrease by
1
minute. The LED will
display the current set value.
c. The Auto Close function will be disabled when the setting is
0
.
d. Press
SET
to store your setting.
Note: Auto close is only available when door is at its fully open position. When using
auto close, photo beams must be fitted.
6. Coding and Deleting Transmitters (Maximum 20)
a. Momentarily press
CODE button.
A Red dot will appear on the display.
b. Press and release a button on the transmitter, the Red dot will disappear, press the
same button a second time, the Red dot will flash and then be replaced by a
U
on the
LED display. Transmitter is programmed successfully.
c. Repeat step b. to code a maximum of 20 transmitters.
d. To delete transmitters, press and hold
CODE
, the LED display dot will flash, keep
holding for approximately 8 seconds until the LED display flashes a
C
. Release button.
All transmitters are now deleted.
SETTINGS AND ADJUSTMENTS
