11
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
SUPERIOR
®
DIRECT-VENT GAS FIREPLACES • MODELS SLDVT-30/35/40/45 • CARE AND OPERATION INSTRUCTIONS
Figure 6:
Installing and Removing the
Glass Door
Installing the Glass Enclosure Panel
1. Retrieve the glass enclosure panel. Visually
inspect the gasket on the back side of the
frame. Gasket surface must be clean, free of
irregularities and seated firmly.
2. Position the door in front of the firebox
opening with the bottom of the door held
away from the fireplace at a 45° angle
(
Figure 6
)
. Hook the top flange of the door
frame over the top of the firebox frame.
3. Let the bottom of the door frame swing
gently in towards the fireplace ensuring
that the gasket seats evenly as the door
frame draws shut. Fasten the two latches
located underneath the firebox floor to the
door's vee-flange. Close both the latches
securely.
4. Reinstall the control compartment door
(
Page 8
).
5. If the hood was uninstalled, reinstall the
required hood. Note the location of the
three clips inside the top air channel above
the door. The clips are equally spaced on
the top surface of the air channel opening.
Use a screwdriver to open the clips
slightly if needed. Engage the back edge of
the hood into the clips to secure.
Front Glass Enclosure Panel, Removal
and Installation
Control
Compartment
Panel
Glass
Door
Glass Door
Spring Latch
Hood
WARNING
Any safety screen or guard
removed for servicing the appli-
ance must be replaced prior to
operating the appliance.
AVERTISSEMENT
Tout écran ou protecteur retiré
pour permettre l’entretien de
l’appareil doit être remis en
place avant de mettre l’appareil
en marche.
WARNING
•
Do not attempt to substitute the
materials used on this door,
or replace cracked or broken
glass.
•
Handle this glass with extreme
care! Glass is susceptible to
damage – Do not scratch or
handle roughly while reinstall-
ing the glass door frame.
•
The glass door(s) of this appli-
ance must only be replaced as
a complete unit as provided
by the manufacturer. Do not
attempt to replace broken,
cracked or chipped glass sepa-
rately.
•
Do not attempt to touch the
front enclosure glass with your
hands while the fireplace is in
use.
WARNING
Do not operate appliance with
the glass front removed, cracked
or broken.
AVERTISSEMENT
Ne pas utiliser l'appareil si le
panneau frontal en verre n'est
pas en place, est craqué ou
brisé.
Only doors certified with the appliance
shall be used.
Seules des portes certifiées pour cet
appareil doivent être utilisées.
CAUTION: DO NOT abuse glass door by
striking or slamming shut.
These are direct-vent appliances. They are
designed to operate only when the front glass
enclosure panels are installed. Generally
the front glass enclosure panel should not
be removed except to gain access to the
components within the firebox.
Removing the Glass Enclosure Panel
1. Open the lower control compartment door
(
Page 8
).
2. Locate the two (2) latches (
Figure 5
) at
the top of the control compartment and
disengage them from the door frame
bottom vee-flange.
3. Pull the bottom of the door out a few
inches and grasp it on the right and left.
Gently lift it to release the door from its
channel above the door.
4. Set the glass enclosure panel aside in a
safe place for later reinstallation.
Note: When installing the glass door, ensure the
spacing on both sides are equal.
