Superior DRT4036TEN, Инструкция по установке и эксплуатации

Страница: 28 / 44

www.SuperiorFireplaces.US.com
126721-01A 28
WARNING: Only parts sup-
plied by the manufacturer
should be used when replacing
broken or damaged glass door
panels (see Replacement Parts ,
page 39). Glass door panel are
complete units. No substitute
materials may be used.
CAUTION: Wear gloves and
safety glasses while handling or
removing broken glass. Do not
remove if glass is hot. Keep chil -
dren and pets away from glass.
If glass has been broken, carefully remove
glass door (see Removing/Replacing Glass
Door , page 20). Vacuum all glass pieces with
a shop vac.
CAUTION: Do not vacuum if
pieces are hot.
Use only glass door replacement intended for
this fireplace (see Replacement Parts , page
39 for detail on ordering). No substitutions
may be made. See Removing/Replacing
Glass Door , page 20 for instructions for re -
placing glass doors.
WARNING: Do not operate
fireplace with glass door un -
latched, removed, cracked or
broken.
CLEANING AND MAINTENANCE
Continued
PILOT AND BURNERS
• Remove material before cleaning burners
and replace when cleaning is complete.
• Burner and controls should be cleaned with
compressed air to remove dust, dirt or lint.
• Use a vacuum cleaner or small, soft bristled
brush to remove excess dust, dirt or lint.
LOGS
• Use a vacuum cleaner to remove any
carbon buildup on logs.
• Replace material periodically as needed.
See Replacement Parts , page 39.
VENTING SYSTEM
Conduct annual inspection of the venting
system following these guidelines:
1. Check areas of venting system that are
exposed to the weather for corrosion (rust
spots or streaks and, in extreme cases,
holes). Have these items replaced im -
mediately by a qualified service person.
2. Remove the vent cap and shine a flash -
light into the vent. Remove any foreign
material.
3. Check for evidence of excessive con -
densation. Continuous condensation can
cause corrosion of caps, pipes and fittings
and can be caused by having excessive
lateral runs, too many elbows or exterior
portions of the system being exposed to
cold weather.
4. Inspect joints to verify that no pipe section
or fitting has been disturbed and loos -
ened. Check mechanical supports such
as wall straps for rigidity.