Superior Signal Company LLC
AccuTrak
®
VPE-
1000 User’s Manual
© 2015
9
Setting the Sensitivity:
The AccuTrak
®
VPE-1000 always defaults back to sensitivity as the active mode.
This means that after any other adjustment has been made, it will hold the
setting in memory, and reset it
self so that “
” and “
” adjust sensitivity.
Pressing the “
” and “
” arrows will adjust the sensitivity while in either the
Airborne or Touch probe mode. The prefix on the A.N.D. indicates the active
mode being changed. For example, the display will read “
A
000” to
show that you
are adjusting the airborne sensor’s sensitivity, or “
P
000” to indicate that you are
adjusting the sensitivity of the touch probe sensor.
Setting the Volume:
While using either the Airborne or Touch probe
mode, pressing the “MODE”
button once will put the AccuTrak
®
in the Volume Adjust Mode. The
alphanumeric display will read “Vol” as long as the MODE button is pressed.
When released it will show “V000” indicating the current volume setting. Use the
“
” and “
” buttons to make the adjustment. You will hear the volume change
as the dis
play changes from “V000” to “V255” (the “V” prefix indicates that
volume is the current mode being adjusted).
Note:
Volume and sensitivity are not the same.
Volume
adjusts the loudness
of the signal in the headset.
Sensitivity
adjusts the meters reaction to the
incoming signal. This capability allows you to
Audio Zoom
into the signal that
you hear. If the incoming signal is too loud reduce the sensitivity and Zoom in
with the volume to hear subtle changes in the sound. Similarly if the signal is
too weak increase the sensitivity and Zoom out with the volume to reduce the
noise in your ears and listen carefully for differences.
