6. Finally, take the two remaining coals and place at the back of the
fuel matrix, in the centre as shown in figure 12. Adding these coals
should complete the appearance of the fuel bed giving an even dis-
tribution of equally spaced coals.
IMPORTANT : The fire is designed to operate correctly
with the coals supplied when assembled according to the
instructions. Never add to the sixteen coals, or change
them for a different type. Never throw rubbish or other
matter onto the coal bed.
1. Refer back to section 6.0 - Fuel bed layout - coal effect and follow
steps 1 and 2. The front strip and fuel effect matrix used for pebble
effect versions are of the same design as coal effect versions, but have
a different surface finish. Position them as shown in figure 13.
2. Open the bag of 16 ceramic pebbles. All of these pebbles are the
same size. Take five pebbles and place them as shown in figure 14.
Care should be taken to ensure that the pebbles bridge the gap
between the front strip and the four supports at the front of the
matrix. Care should also be taken not to push the pebbles right
down between the supports, as this can affect the flame picture
when the appliance is running.
3. Take five more ceramic pebbles and position as shown to form the
‘second row’ of the fuel effect as shown in figure 15. The pebbles may
be rotated as desired to fit into the gaps between the supports in
order to create a random, realistic effect. Again, remember not to
push the pebbles down too far into the valleys between the supports
as this can have a detrimental effect to the flame picture.
4. Now take another two pebbles and place behind the second row of
pebbles next to each other in the centre of the fuel bed as shown in fig-
ure 16. The pebbles may be orientated as desired to achieve a realistic
effect. Keep the spacing between the pebbles even and uniform.
6.0 FUEL BED LAYOUT
(COAL EFFECT) - CONTINUED
4
©
2011 Focal Point Fires plc.
GB IE
Figure 12
6.1 FUEL BED LAYOUT
(PEBBLE EFFECT)
Figure 13
Figure 14
Figure 15
Figure 16
