SuperiorFireplaces.us.com
126709-01_C
14
INSTALLATION
Continued
Figure 14 - Installing Fireplace Screen
(Model May Vary From Illustration)
Screw
Rear Hole
Top View of Rod Layout
Rod
Front Hole
Ring
Screen
Identifi cation
Label
Location
Figure 13 - Hood Placement
(Model May Vary From Illustration)
2. For Indoor/outdoor models, loosen screws
along the fi replace top face. Remove two
screws along fi replace face side. Slide
hood underneath screws on top and
tighten screws. Replace screws on side
of fi replace face side securing hood to the
face
(see Figure 13)
.
3. Insert each screen rod through all rings
located at top of screen.
4. Insert
fi rst rod into rear hole in left side of
fi rebox. Fasten rod to rear hole near center
of fi rebox using #10 x 3/8" Phillips screw
provided
(see Figure 14)
.
5. Insert other rod into front hole on right
side of fi rebox and fasten using remaining
Phillips screw.
Hood
Remove/Replace
Side Screws
Loosen Top
Screws
Figure 12 - Hood Placement
(Model May Vary From Illustration)
Hood
OPTIONAL OUTSIDE AIR KIT
(MODEL AK4/AK4F)
Installation of outside air kit should be per-
formed during rough framing of fi replace due
to the nature of it's location. Outside combus-
tion air is accessed through a vented crawl
space (AK4F) or through a sidewall (AK4).
See
Figure 11
.
Figure 11 - Outside Air Kit
Secure to Collars with Metal Tape, Screws
or Straps (Min. of 1/4" x 20" in size)
Air Inlet
Location
Must Allow
For Bushes
or Snow
Vent Hood
Required for
Wall Installation
Air Inlet
Eyebrow
Vented Crawl Space
(Check Local Codes
Before Installing in a
Vented Crawl Space)
CAUTION: Combustion air
inlet ducts shall not terminate
in attic space.
INSTALLING FIREPLACE HOOD
AND SCREEN
1. For Indoor models, attach hood and front
panel assembly by snapping panel assem-
bly into fi replace opening
(see Figure 12).
