www.SuperiorFireplaces.US.com
127035-01A
16
GLASS PANEL INSTALLATION
The glass panel assembly should be installed
after the fireplace is completely framed and
finished. The brackets are attached to the front
side face of the fireplace using two screws as
shown in Figure 25. Position the glass panel
in the bracket so that it is securely in place.
The glass panel can be placed in two different
height locations.
INSTALLATION
Continued
Glass
Panel
Bracket
Screws
Remote/Off Switch
ADJ.
“S” Pilot Connection
“I” Pilot Connection
AF-4000 MOD Module Rt Side
Figure 26 - Gas Module Right Side
AF-4000 MOD Module Lt Side
AUX Connection
Learn Button
Figure 27 - Gas Module Left Side
Figure 25 - Installing Glass Panel
GAS CONTROL MODULE SYSTEM
REMOTE CONTROL FEATURE
The module has a built in remote control
receiver that allows the user to program
the remote transmitter at any time during or
after the installation of the burner.
1. There is a switch located on the right
side of the module that reads RE-
MOTE/OFF (Figure 26).
2. When the remote/off switch is in the
OFF position, the burner will operate
from the rocker switch or wall switch
connected to the two BROWN wires
on the module.
3. When the remote/off is in the REMOTE
position the burner will operate from
the Remote Control Transmitter.
NOTE:
The module must be programmed to
the Remote Control Transmitter.
•
To program the module (make sure the
system has power), locate the learn but
-
ton (Figure 27) on the module. Locate
the metal shield that is covering the
module and remove the screw on top.
Use a small thin object like a paper clip
(not sharp points) to press and release
the learn button. There will be a beep
sound from the module. Then press any
button on the remote transmitter. Once
the module's internal receiver accepts
the transmitter code, there will be a
series of confirming beeps.
•
The remote system is ready for use.
•
Pushing and holding the LEARN but-
ton for 6 seconds will result in clearing
the transmitter security code from the
module's memory. The module will make
three long beeps in succession when it
has been cleared.
