Operation
900948-00C, 06/2019
Innovative Hearth Products
DRT2000-C Series Direct-Vent Gas Fireplaces
61
2
Installing the DRT2000-C 45 Series Log Set
The logs have notches/tabs to assist proper positioning. Upper logs rest on lower logs via notches/tabs. Proper log placement is
critical to prevent sooting. Place the logs in the gaps between flame peaks, so they do not impinge the flames. Follow the log placement
instructions precisely.
NOTE:
Do not cover the burner ports.
Table 32 - Log Set
I.D.
No.
Description
1
Front Left Log
2
Front Right Log
3
Back Left Log
4
Back Right Log
5
Twig Log
1.
If necessary, remove the glass door (Pages 63-64). Locate the placement tabs (Figure 54).
2.
Bend up the log placement tabs (Figure 54).
3.
Install the front left log (1) (Figure 55).
Figure 54 - Locate the log placement tabs
Figure 55 - Place front left log (1)
4.
Install front right log (2) on two tabs (Figure 56).
5.
Install back left log (3) on two tabs (Figure 57).
Figure 56 - Place front right log (2)
Figure 57 - Place back left log (3)
Catalog number for the entire set: See Page 77.
1
3
5
4
2
4
3
5
1
a
b
c
d
e
f
Pin for
Log #1
Pin for
Log #2
Tab for
Log #1
Tab for
Log #3
Tab for
Log #4
Tab for
Log #2
Bottom View
Top View
1
Fits over Tab “a”
(Figure 54)
Fits over Pin “b”
(Figure 54)
1
1
2
2
Fits over Pin “d”
(Figure 54)
Fits against Tab “f”
(Figure 54)
Bottom View
Bottom View
Top View
Front View
3
Fits over Tab “c”
(Figure 54)
Install log on pin (d) first then rotate log until right rear corner contacts bend
up tab (f) or the edge of log is flush with bend down on floor (as seen below)
This edge should be flush with bend down in floor after installation
