Operation
900004-00, 03/2018
Innovative Hearth Products
DRT2000 and DRC2000 Direct-Vent Fireplaces
53
Installing the logs - 33” and 35” Traditional Models
The logs have notches/tabs to assist proper positioning. Upper logs rest on lower logs via notches/tabs. Proper log
placement is critical to prevent sooting. Place the logs in the gaps between flame peaks, so they do not impinge the
flames. Follow the log placement instructions precisely.
NOTE: Do not cover the burner ports.
NOTE: Ensure the left front log (1) and right front log (2) are correctly installed on the burner positioning pins.
Table 38 - DRT2033 and 35 Log Sets
Log Number
Description
1
Rear Log
2
Left Front Log
3
Right Front Log
4
Left Cross Log
5
Right Cross Log
4
5
3
2
1
NOTE: It is important to ensure proper log placement per the
manual when installing these units. Verify pilot flame is not
obstructed. See Verifying Appliance Operation on Page 39.
1. If necessary, remove the glass door (Page 56). Locate and bend up Burner Locating Tabs (Figure 47).
2. Locate the log placement brackets (Figure 47). Place embers and other media (see Page 52).
Figure 47 - Locating the log placement brackets
Figure 48 - Placing logs 1 and 2
Left Log Bracket (front & rear) Right Log Bracket (front & rear)
Left and Right Burner Locating Tabs
1
2
3. Align the notches in the bottom of the rear log (1) with the left rear brackets (Figures 47 and 48).
4. Position the left rear log (1) on the left rear bracket and the left front log (2) on the left front log bracket and the
left burner locating tab (Figure 48).
Figure 49 - Placing log 3
Figure 50 - Placing logs 4 and 5
3
4
5
5. Position the right front log (3) on the right front log bracket and right burner locating tab (Figure 49).
6. Position the left cross log (4) on the left rear log (1) and right cross log (5) on the right rear log bracket
(Figure 50).
Catalog number for the entire set:
F1883 - 33” Models
F1829 - 35” Models
