Superabrasive Lavina Elite L20EU, Руководство пользователя

Страница: 29 / 42

Superabrasive User Manual Original Language Lavina
® 20EU
6/2020
29
ATTENTION: NEVER “OVER” TENSION THE BELT, THE BELT WILL BE DAMAGED AND IT WILL NEVER RECOVER ITS
ORIGINAL TENSION
Tighten the two nuts on the sectors and contra nut on the tensioner (Fig. 8.12.9). Put the seal ring on the bottom cover and
close the machine (Fig. 8.12.11).
Reassemble in the same manner.
Your LAVINA® ELITE machine is now ready for use!
8.11 CHECKING THE TENSION OF THE BELT
Open the checking cover to reach the belt and tension device (Fig.8.13.1). You should rotate the whole system by hand and
check the tensioning several times to ensure its equal in all the regions of the belt. It is recommended that the tensioning
of the belt be measured with Optikrik II Device (Measuring range: 500 -1400 N) (Fig.8.13.2). Тhe tension of the existing belt
must be 520 N.
ATTENTION:
NEVER “OVER” TENSION THE BELT, THE BELT WILL BE DESTROYED AND IT WILL NEVER RECOVER ITS ORIGINAL TENSION
Loose the contra nuts (Fig.8.13.3), loose light the two nuts of the tension device (Fig.8.13.4), and adjust the tension with the
nut seen in. When the right tension is reached: close the contra nuts and the two nuts of the support. Reassemble in the
same manner.
PLEASE MAKE SURE YOU CHECK THE TENSION OF THE BELT AFTER THE FIRST 15 HOURS OF OPERATION.
9. DISPOSAL
If your machine after time is not usable or needs to be replaced, send the machine back to Superabrasive or a local
distributor, where a professional disposal complying with the environment laws and directives is guaranteed.
10. MANUFACTURER’S CONTACTS
If you need to contact Superabrasive Inc. with technical support questions, below is the contact information.
Address:
9411 Jackson Trail Road, Hoshton GA 30548, USA
Email: info@superabrasive.us
Tel.: 706 658 1122
Fax: 706 658 0357
Figure 8.25
Figure 8.13.1
Figure 8.13.2
Figure 8.13.3
Figure 8.13.4