Superabrasive User Manual Original Language Lavina
® 20EU
6/2020
22
8.2 DISMOUNTING/MOUNTING
THE GUARD
You can dismount and mount the safe
guard without separating the carriage from
the main head. Put the machine in position
to change the tools. Unscrew the four bolts
M5 from the metal cover preventing the
safe guard to fall. Dismount one of the
three holders. Dismount the safe guard.
8.3 REPLACING POWER CORD AND
PLUGS
When replacing the power cord or plugs,
always use cords and plugs with specifications as the original ones.
Never use lower quality or different type cord and plugs.
In addition, take into consideration the distance of the appliance from the electrical source. The greater the distance, the
greater the resistance and the less current that will be available at the other end; there will be a voltage drop and the
inverter will sign alarm mode. This can also happen if several machines are working on the same line or when the generator is
underrated. In general our standard power cable can be doubled in length; if longer lengths are needed you have to replace
all the cables with bigger gage rated cables for the length and amperage.
8.4 DISMOUNTING TOOL HOLDER TO CHANGE V-RINGS AND FELT-RINGS
To check or replace the buffers and the elastic elements, the tool holders have to be dismounted.
You will need a 13mm deep metric socket with an outside diameter of no more than 3/4in to unscrew the four bolts (Fig.8.5.1)
and remove the holder (Fig.8.5.2) When the tool holder is dismounted, you can change the sealers (V-Ring and Felt-Ring).
By loosening four Hex cap flange bolts (Fig.8.5.3) the adaptor comes loose. Unscrew the six screws of the cap (Fig.8.5.4) holding
the felt-ring. Take out the Felt-Ring, adaptor and V-Ring.
Mount the V-Ring with the smallest lip of the V to the inside (Fig.8.5.5) - simply push the V-Ring so the top is on the same
level as the pulley top (Fig.8.5.6). Then take the adaptor and push the V-Ring down with the adaptor (Fig.8.5.7). The lowest lip
of the V-Ring should only barely touch its gliding surface. Mount the adaptor and the Felt-Ring on top (Fig.8.5.7). Close the
sealers with the cap (Fig.8.5.8) and screw the bolts. Always use the original bolts. Do not push the V-ring down with fingers.
Figure 8.5.1
Figure 8.5.2
Figure 8.5.3
Figure 8.5.4
Figure 8.5.5
Figure 8.5.6
Figure 8.5.7
Figure 8.5.8
Figure 8.3
Figure 8.4
Содержание Lavina Elite L20EU
