30
LIGHTING SYSTEM
SEAT
The RX model lighting system is wired into the main harness of the electric bike. For
replacement, you must disconnect the cables on both the rear brake light and front light
and get new parts. There are no batteries in the lights. Make sure the front and rear
lights are clean before riding. If they are dusty, or dirty, clean them with a damp cloth for
optimal visibility and safety.
It is not possible to adjust the seat height of the Super73. It is fixed to the frame
by bolts. The minimum seat clamping torque on the frame is 6.78 (Nm) 5lb / ft. For
maintenance, use a cloth and water with a gentle soap for cleaning. Avoid leaving the
seat too long in the sun, as the fabric can be damaged by the sun’s UV rays. Avoid
wearing clothes that may puncture or tear the seat.
The bike is subject to wear and tear, like all mechanical parts. Materials and parts react
differently to wear and abrasion. If the intended life of a part is exceeded, it is possible
that it will suddenly fail, which represents a certain danger for the rider. Any type of
cracks, streaks, or color changes in highly stressed areas indicate the maximum wear of
a part. It must, therefore, be replaced immediately. It is important to use genuine
properly specified parts for safety-critical components during the replacement of worn
parts.
!
Suspension
Suspension components will require regular maintenance, cleaning, and greasing in
order to keep the movement of these components fluid and in good working order. It is
recommended to regularly inspect each component of the suspension for signs of wear.
Failure to maintain, check and properly adjust the suspension system may result in
suspension malfunction, which may cause you to lose control and fall.
!
