12
ACRO BASE SYSTEM
SUPAIR manufactures its products in Europe. The majority of the components used
come from Europe.
Setting up the release system.
1
BS Handle
Step 1 :
Push the cables through the pulleys,
then slide them into the sleeve. Finally,
insert the cables in the elastic guide (
right side ).
Step 2:
Push the first ring in the carabiner. Then
push the second ring inside the first
ring and place the white flat loop in
the second ring using the packing line
( 8, in blue ).
Step 3:
Using the packing line, push the white
flat loop through the grommet on the
bridle, then insert the cables through
that loop coming out on the other side
of the grommet.
First ring.
Second ring.
White flat loop.
Grommet.
Pulleys.
Cable handle
sleeve.
Line
Carabiner.
Step :
Check
thoroughly
that all is properly
installed during a
test on the ground.
You CAN NOT have any doubt
about the installation proce-
dure! If the case, start it all over
again.
Check the release system prior
each takeoff !
DO NOT use any carabiners
other than those provided by
the manufacturer.
Elastic guide.
A
B
C
E
D
F
H
I
J
G
A
C
D
E
F
1
G
2
3
4
B
C
D
E
B
J
G
I
