SUNWARD SWE25UF, Руководство по эксплуатации и техническому обслуживанию

Страница: 37 / 106

32
2) Turn key switch to ON position, all indicator lights come on except engine hour meter and
LCD module, buzzer tweets, self inspection is finished after 2 seconds and the monitor
system is on normal working condition.
Start engine
1) Keep pilot valve control lever locked.
2) Turn key switch to ON position.
3) Beep horn to warn surrounding people.
4) Start engine by turning key switch clockwise to START position. Release key, the switch
will return to ON position.
Start engine in cold weather
1) Turn key switch to ON position.
2) Screw key switch to start position and keep a few seconds.
3) Screw key switch anticlockwise to HEAT position, about 30 seconds later, indicator light
comes on, it means the preheating work is finished,
4) When preheating light comes on, start engine.
Adjust engine rev
When accelerograph handle is lifted to upmost and engine runs at full load; lower handle to
bottommost, engine runs at minimum load; adjust accelerograph between upmost and
bottommost to control engine rev, and also you can screw handle to adjust accelerograph
imperceptibly.
Stop engine
1) Lower the bucket to ground.
2) Place the accelerograph handle to minimum load position for about 5 minutes.
3)
Screw key switch to “OFF” position to stop engine, and take out key.
4) Pull pilot control lever to LOCK position.
In order to avoid damage of starter, never operate motor starter for
10 seconds or more every time. If the engine can ’ t start, turn the
key switch to OFF position and wait at least 2 minutes, then try again.
After the wrong start, the engine should be stopped completely, then
you can turn key switch, otherwise it may damage starter.
If there is a flicker in monitor, stop engine at once and check the
reason.