Suntor ST5XHPT, Руководство пользователя

Страница: 4 / 12

4th
12) After starting the product, the self-test indicators of ST5XHPT will continuously blink for 30s and
then keep bright. Only after the video from the camera shown on the display, then you can
confirm that the device work properly now.
13) Check the surrounding environment to ensure there is no other 2.4GHz devices to cause
interference.
14) If you use the Futaba remote controller, the controller should be adjusted into the French mode.
Otherwise, the video transmission performance will be serious affected
15) Adjust the Futaba controller into French mode as following steps:
16) [LINKAGE MENU]→FRQUENCY→ RTN b→ [AREA]→[FRANCE]
Or connect ST5XHPT S1 serial port with trainer interface on back side of Futaba by TTL cable. And
set the Futaba RF as OFF. Through the S1 port uplink the PPM/SBUS signal.
17) Before using, please check the power of RX and TX. If the receiver power off, transmitter on
board will lose connection.
18) Adjusting RX antenna inclination can improve the signal strength and image quality.
19) The camera should be fully charged to ensure normal video output.
20) ST5XHPT support video and duplex data communication. If the video stuck or stopped for more
than 10s. It means the radio signal is weakened or the radio channel is narrowed. In this case,
the aircraft need to fly back to short the distance between TX and RX. Otherwise, the TX will
lose connection.
21)
Please use good electromagnetic shielding accessories(HDMI Cable, HD display and so on)
Notes: Improper operation of ST5XHPT may cause personal injury or damage to properties. Please
pay high attention to operation safety.
III. List of in-box items
On board x1 Ground terminal x1