HYBRID INVERTER | Installer Manual
44
What you can do from this page:
Set up you Lithium-ion battery.
After installing a lithium battery, check the communications page by clicking on the ‘Li BMS’ icon to see if
the BMS information is visible. Suppose some information is not displayed correctly (it should look like the
diagram below), then there will be a communication error.
Therefore, if a communication error occurs:
1. Check that your data cable is the correct type.
2. Check that the data cable is plugged into the correct sockets. Usually, RS485 is employed, but some
battery manufacturers use others.
PLEASE NOTE
With some types of lithium batteries, the BMS cannot be controlled by the Sunsynk inverter. In this
case, treat the battery as a lead-acid type and set the charging and discharging protocol following the
battery manufacturer's specifications.
It is crucial to refer to the manuals that manufacturers produce for their batteries. That way, the chance of
errors occurring during installation is significantly reduced. Below is a list of batteries that have been exam
-
ined, tested, and approved by Sunsynk.
Brand
Model
48V
Storage
Inverter
RS485
or CAN
Inverter
Setup
Notes
DYNESS
B4850
CAN
0
POWERBOXF
0
SolarMD
SS4074
CAN
0
To be used with V2 Logger
http://solarmd.co.za/
inverter-compatibility-so-
larmd/ sunsynk-and-solar-
md/
SS4037
0
SS202
0
SHOTO
SDC10-Box 5
CAN
0
