5-1
UV-C lamp shell body
5-5
45×4 O-ring
5-9
UV-C device head with cable
5-2
Spiral sleeve
5-6
Quartz glass tube sleeve
5-10
Safety clasp
5-3
Quartz glass tube
5-7
60×3.1 O-ring
5-4
Fasten screw
5-8
Uvc bulb
11-1
Impeller cover
11-3
rotor
11-5
Shaft
11-2
Rubber bearing
11-4
O-ring
11-6
Shell body
Operation
1. The device is designed for use under water. Make sure that the device is completely sub-
merged in the water. It must not be more than 2 m below the surface of the water.
2. If the water depth is not sufficient to completely submerge the device, it must not be used.
There is a risk of irreparable dry-running damage to the device.
3. Parts of the UV lamp are made of glass; you must therefore ensure that the device does not
fall or be hit hard. There is a risk of breakage.
4. Please install all parts completely before plugging in the power plug.
5. The device must not be used if there is any damage to it, the power cord or the lamp. Check
thoroughly before commissioning.
© by WilTec Wildanger Technik GmbH
Item 50945–50947
Page 7
http://www.WilTec.de
http://www.aoyue.eu
12 2020
-1
