PART NO. 690963 REV: A-01
29
RC401 Remote Control instructions
RC401 Basic Instructions
Note: Exit
‘
PROGRAM MODE
’
to operate the lift.
Add Transmitter: Press and release the Red
‘
Program
’
button once so the
‘
Add Trans-
mitter
’
light flashes, then press
‘
Up
’
on the transmitter three (3) times.
Clear Memory: Press and hold
‘
PROGRAM
’
button for 15 seconds.
Security Mode: This mode disables the keypad on the controller. To turn on the
Security Mode, press
‘
PROGRAM
’
twice to scroll to
‘
Security
’.
Enter the security code and
press
‘
PROGRAM
’
(combination of 1, 2 and 3). The
‘
Security
’
light will remain lit when the
keypad is disabled. To enable the keypad, enter the correct security code and press
‘
PROGRAM
’.
Depressurize: This feature depressurizes the hydraulics on SunLiftTM and some
FloatLiftTM models for hose removal. Press
‘
PROGRAM
’
three (3) times to scroll to
‘
DEPRESSURIZE
’.
Press
‘
Up
’
then
‘
Dn
’
on the keypad or the transmitter key FOB.
Installation Instructions (if not installed by factory)
The RC401 is compatible for lifts that use the previous RC306, RC308, RC400 and RC400B.
However, the transmitters used with RC306 are not interchangeable with the others.
1. Connect the RC401 to the 6-pin connector of the hydraulic pump wire harness.
LA-RCX12 wire extension is available.*
2. Attach the RC401 to the reservoir of the hydraulic pump with the included Velcro
strips. (For metal Powerpack boxes, attach to inside of Powerpack box).
3. Position the antenna away from the electric motor motor of the hydraulic pump. (For
metal Powerpack boxes, or if Powerpack is located in a metal enclosure, extension
antenna LA-RCA1 is required).
A 12 inch 6-pin extension wire harness is available (LA-RCX12) if existing pump
wire harness is too short (for example: Dual Mini). If a small amount of exten-
sion is needed, the existing wire harness can be adjusted by rerouting the wires
and trimming the existing wire shrink wrap.
Battery Monitoring
The
‘
Battery Fault
’
indicator lights when the battery voltage is low. Charge the battery
with an AC charger if the
‘
Battery Fault
’
light is on. Solar panels will not charge a dead
battery.
Lights Plug
Optional underwater or Dock LED lights are available for SunLiftsTM and FloatLiftsTM(LA-
LP1), and are connected directly to the
‘
LIGHTS
’
plug on the side of the RC401. The lights
are controlled with the
‘
LIGHT
’
button on the transmitter and are latched on for 5 minutes or
may be toggled
‘
Off
’
by pressing the
‘
Light
’
button again. Do not exceed 5A (protected by
the auto-resetting circuit).
