Sunred LH15B, Инструкция пользователя

Страница: 6 / 62

6
For your safety
Heater stand and location
•
The heater is for outdoor use only. Always ensure that adequate fresh air ventilation
is provided.
•
Always maintain proper clearance to non protected combustible materials i.e. top
100 cm and sides 100 cm minimum.
•
Heater must be placed on level firm ground.
•
Never operate heater in an explosive atmosphere like in areas where flammable
liquids or vapors are stored.
•
To protect heater from strong wind, anchor the base securely to the ground with
screws.
Gas requirements
•
Use propane, butane or their mixtures gas only.
•
The pressure regulator and hose assembly to be used must conform to local standard codes.
•
The installation must conform to local codes, or in the absence of local codes, with the standard for the storage and
handling of liquid petroleum gases.
•
A dented, rusted or damaged tank may be hazardous and should be checked by your tank supplier. Never use a tank with a
damaged valve connection.
•
The tank must be arranged to provide for vapor withdrawal from the operating cylinder.
•
Never connect an unregulated tank to the heater.
Leakage test
•
Gas connections on the heater are leak tested at the factory prior to shipment. A complete gas tightness check must be
performed at the installation site due to possible mishandling in shipment or excessive pressure being applied to the
heater.
•
Make a soap solution of one part liquid detergent and one part water. The soap solution can be applied with a spray bottle,
brush or rag. Soap bubbles will appear in case of a leak.
•
The heater must be checked with a full cylinder.
•
Make sure the safety control valve is in the OFF position.
•
Turn the gas supply ON.
•
In case of a leak, turn off the gas supply. Tighten any leaking fittings, then turn the gas supply on and re - check.
•
Never leak test while smoking.
Warning!
Do not make any changes to the device in any way. Incorrect installation, improper use, changes or modifications to the device
may damage or cause injury. Manufacturer and importer can not be held responsible.
EN
3 2