sunjoe 20ViONLTE-ST11-RM, Руководство оператора

Страница: 16 / 24

16
5. Insert the line end through the slot on the hub and gently
press the spool down. Reinstall the spool cover by
depressing the release tabs into their slots in the hub, and
push down until the spool cover clicks into place (Fig. 2 8).
6. Reinsert the battery and turn the tool on. In a few
seconds, you will hear the line being cut automatically to
the proper length.
Winding the Line
NOTE: A single-line factory wound spool (model 20ViON-
STRS-6PK) is available for easy spool replacement on
the 20ViONLTE-ST11-RM cordless t edger. Visit
sunjoe.com to purchase this accessory online. Should you
wish to wind the line yourself, the instructions are provided
below. Self-winding, however, is NOT recommended because
if the line is not wound properly it can cause the trimmer’s auto
feed system to malfunction. For this reason, users are strongly
urged to purchase the pre-wound spool.
1. Stop the machine and remove the battery.
2. To remove the spool from the trimmer hub, follow steps
1 and 2 from the section "Replacing the Spool + Clearing
Jams and Tangled Lines" beginning on page 15.
3. Use a new piece of 0.047 inch nylon line (up to 17.4 feet
total), and insert the end of the line into the small eyelet
on the spool in the direction of the arrows (Fig. 29).
4. Pull the trimming line and bend it over. Wind all the
trimming line firmly around the spool in direction of the
arrows on the spool (Fig. 30).
5. Re-install the spool as instructed in steps 4 to 6 of
"Replacing the Spool + Clearing Jams and
Tangled Lines".
m
CAUTION!
Catapulted pieces of nylon line may
cause injury.
NOTE: The maximum recommended length of line in the spool
is 16.4 ft (5 m).
m
WARNING!
Pay attention to the winding direction.
NOTE: Always replace the spool with a new pre-wound spool.
Visit sunjoe.com to purchase the pre-wound spool
(model 20ViON-STRS-6PK) for this cordless t edger.
IMPORTANT: Keep all areas of the cutting head and cutting
head cover clean. Place the cap back by pushing it firmly
onto the cutting head. To ensure that the cutting head cover
is correctly fitted, try to remove it without depressing the two
latches. If it is correctly fitted, it should not move.
Fig. 28
Trimming line
Spool cover
Slot
Fig. 29
Eyelet
Follow the
direction of the
arrow
Fig. 30
Follow the
direction of the
arrow